Watch this video if you are awaiting delivery of your first Emlid Reach RS2!
Below are chapter links if you want to skip ahead. There are a heap of handy tips along with the steps you’ll need to follow in order to get your receiver ready to start work.
The 5 essential steps are:
1) Power on the charged receiver – it will create a Wi-FI network called “Reach:XX:XX”
2) Connect to that Wi-Fi network with a phone or tablet running the Reachview3 App
3) Provide the receiver with credentials for a local Wi-Fi network connected to the Internet. This will allow the receiver to download the latest firmware.
4) Reconnect to the RS2 receiver from your device via the same local Wi-Fi network.
5) Name the receiver and complete the setup process including any firmware updates.
00:00 Unboxing the RS2
01:56 Receiver overview
02:20 IP67 rating
02:50 Antenna Tips
03:20 Low battery level
03:50 Use the correct USB C cable for charging!
04:23 Boot sequence
05:37 Wi-Fi Hotspot mode
05:56 Connect to the receiver via Reachview3
06:30 … or connect to ReachView2 via a computer via 192.168.42.1
07:00 Setup Reach to join a local Wi-Fi network with Internet access
07:35 Network status. Be really careful entering your Wi-FI network password!
08:40 Re-connect your device to the RS2 via the common local Wi-Fi network
09:05 Complete the setup process, add a name and download any firmware updates.
10:00 Ready For Work – Stage 1 completed!
source
Hello just want to know which Post Processing software is used to remove the error .Your Recommendation Please
Excuse me ,
Why is the prices are so expensive comparing with the emlid website prices , can you please clarify that ,,,