Extractor Tool: https://amzn.to/3Zic6HF
Propane Torch: https://amzn.to/3ZgYJrc
In this video I demonstrate how to remove a broken threaded PVC pipe. This can be useful when working with threaded PVC sprinkler riser and such.
Disclaimer: Due to factors beyond the control of Bump (@thebumpchannel), we cannot guarantee against improper use or unauthorized modifications of the information provided. Bump (@thebumpchannel) assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Bump (@thebumpchannel) recommends safe practices when working on vehicles, tools, products, or activities seen or implied in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Bump (@thebumpchannel).
Disclaimer: As an Amazon Associate I earn from qualifying purchases.
source
Extractor Tool: https://amzn.to/3Zic6HF
Propane Torch: https://amzn.to/3ZgYJrc
Thank you so much!!! The heating idea worked.
Good man!
Fabulous! Worked like a charm, and saved several hundred dollars in plumbing costs (we live in the middle of Booneysville, MT!)
Thanks for the great ideas. I have a one inch pipe stuck in a quarter. Turn valve for this tool work to remove that piece of pipe, thank you.
what about heating up the extractor?
Thanks bubba, I was fixing broken sprinklers threads and this definitely made it easier.
I used a copper pipe and put it into the hole. I then heated the copper near where it went into the hole. Then I used a chisel that was just bigger than the interior diameter of the threaded pvc piece. I grabbed it with a crescent wrench and was able to twist the broken piece right out.
Thx for the tutorial. I would never have gotten it out without ruining the whole house filter cap which would have been expensive to replace and would have had to have been ordered.
Thank you! Your fix worked perfectly for me in an almost identical situation, (broken threaded PVC irrigation pipe).
That was a cool trick. Good job.
I'm about to tackle the job now, I don't have a tool or rod iron in my arsenal. So, I'll head out back now and let you know how it went with what I have available. Well, I got it out by using a round wire brush I had in my plumbing supply. It was 1/2"x 2" long with a handle. I forced it down in there turned and it came out. Of course, if it were really stuck this would not work, and your tips would be my next stop.
Thank you.
We had a piece of pvc break off in our water well, and we bought one of these from ace hardware, and after prying for a bit the hand of the tool broke. Thankfully we were able to still pry it with a monkey wrench though, and got the pvc out of the thread.
Thank you,
What if there's running water and you can't heat it up?
Worked perfectly! Used the rebar and a blowtorch twice to loosen it. It was in there crazy-tight but it worked! Thanks for the great tip!
Thank you sir! Very helpful 🫡
I had an irrigation fitting break for a cow waterer.
Thank you. This totally worked. The connector for my Pool Polaris pump broke off and I use this technique to get it out. Heated rebar and everything. Thank you.
How can i do for a pipe of 2 inch?
If you don't have a special tool you can drive a chisel that is slightly narrower than the stuck plastic pipe down into the opening. Once it is down a half inch or so get a pair of channel lock pliers and you can back it out of the line or sprinkler head. Works every time for me.
I never knew this tool existed untill I watched your video thank you
THANK YOU FOR THIS!!