Amazon Links
Mars 3 Pro: https://geni.us/ROiS
Washable resin: https://geni.us/CMDn
Recommended: http://geni.us/JustVlads
Test Model: https://siraya.tech/pages/siraya-tech-test-model
ELEGOO Mars 3 Pro 3D Printer, 4K Mono 6.6 Inch LCD MSLA UV Resin Printer with Odor Reducing Facility and Screen Protector, Speedy Printing and High Precision, 5.62×3.5×6.8 Inch Build Volume
6.66” Ultra 4K Mono LCD
Equipped with 6.6” 4K monochrome LCD, Mars 3 Pro can prints out works at 35µm super high XY resolution.
Build Volume 143×89×175mm/5.62×3.5×6.8in, 40% larger than Mars 2. A protective film is installed on the LCD to prevent resin leakage from damaging the screen
High-End COB Light Source
New generation COB light structure is designed with 36 units LED lights, a free-form surface lens and a Fresnel lens, powerful and reliable, resulting in 92% and more uniform UV distribution for higher printing accuracy
Comfortable Printing Experience
Build-in activated carbon reducing bad odor of resin, offer you a more comfortable and fresh experience. ATTENTION USB port next to the vat is for odor reducing facility ONLY
For Better Printing Results
Upgraded Z-axis linear railway make a more stable and accurate moving, ensuring you will get reliable and consistent results. Comes with 2 extra FEP films 2.0, help the prints stick nicely to the build plate and protect small supports from broken, improve completeness of your prints
ELEGOO Authorized Distributor
You will receive ELEGOO Mars 3 Pro, tool kit and 2 extra FEP films as bonus, 1-year warranty
As an Amazon Associate I earn from qualifying purchases
My website: https://www.justvlads.com/
source
🔥💕👍
Cool video, Vlad! Could you please explain the calibration part again. You calibrated using 2 pages of the book. Then said that if you're getting elephant feet raise the foot ca. 10mm and set to Zero there. Now a lot of other people use the paper calibration and then press the set zero, but you didn't at this part. Must one set zero here or is it ok just to tighten the screws and that should be ok?
Can someone print parts of a helmet with this? Like a wearable helmet.
Tank clean button looks like … 🖕 … 🤪👍
For any newbies watching – the fumes from the wet uncured resin are always very present and are called VOCs. You shouldn’t take safety as casually as YouTubers trying to get a good shot. You reallllly don’t want to let even a little bit of this stuff to get on your clothes or skin as it’s a toxic irritant that can give you burns or life long new allergy. The new allergic sensitivity thing can happen from breathing in the fumes as well and the included masks are not good enough.
You don’t need to let it scare you from enjoying this hobby or go totally overboard with your setup and PPE, just protect yourself and don’t use most of these content creators as a guide for your health.